Spray foam insulation
Spray foam seals air while it insulates, so it earns its higher cost when your ductwork runs through a hot attic. When it doesn't, sealing the gaps and topping up loose fill usually wins, and I'll say so.
Trueseal Charleston Insulation Company is an insulation contractor based in Charleston, SC. We insulate attics, walls and crawl spaces across the city and close the drafts around them, and I explain what your house needs first.

Most of our Charleston calls start with an upstairs that won't cool off in summer or floors that feel cold and clammy over the crawl space. A lot of Charleston sits on low ground the city maps into flood zones, so water under the house shapes the job here as much as heat in the attic does. We do the same work across the harbor in Mount Pleasant, out on James Island and up in North Charleston.
The price turns on what's already up there and what has to happen before new insulation goes in, like pulling out wet or dirty material, sealing gaps, or choosing foam over loose fill. The schedule turns on that same prep work, how easy your attic or crawl space is to get into, and whether a permit is needed. I'll give you your own figure on site, in a written quote that shows every step, prep included.
Before I quote, we check whether your address falls under the City of Charleston or the county, since that decides who you'd be dealing with if the work needs a permit.
If we find old wiring or vermiculite, a pebbly loose fill from decades back, we treat it as an ordinary first step and explain what it means before anything else moves.
I walk you through what's up there and why it matters, because I want you to understand your attic and crawl space when we leave, not just know the job got done.
Spray foam seals air while it insulates, so it earns its higher cost when your ductwork runs through a hot attic. When it doesn't, sealing the gaps and topping up loose fill usually wins, and I'll say so.
Most hot-upstairs calls end in the attic, where we check how many inches are already there, keep the eave vents open and bring the edges up to full depth, since that's where coverage usually runs thin.
Blown-in insulation is loose fill we blow through a hose, and it's usually the simplest way to top up an attic that's settled thin over the years. We seal the gaps first so the new layer isn't fighting a draft.
When the whole house feels off, drafty downstairs and hot upstairs, I look at the attic, walls and crawl space together so you get one plan in the order that makes sense, not three separate fixes.
Insulation that's been soaked, flattened or filled with droppings has to come out before anything new goes in, or the problem stays put. We bag it, clean the space and show you what we found.
Charleston crawl spaces sit close to damp ground, so we match the material to how wet yours gets, because batts that soak up water sag and fall. Warmer floors over the crawl space are usually the goal.
Exterior walls in older houses are often empty or only half filled, which you feel as cold walls and drafts in winter. We fill them through small openings and patch the holes when we're done.
Air sealing, closing the gaps around pipes, wires, can lights and the attic hatch, comes before any insulation, because insulation can't stop air that's moving straight through a hole.
Basements are rare on Charleston's low ground, but where a house has one, we insulate the walls with a material that handles damp, so moisture isn't held against the insulation.
Closed-cell foam, a dense foam that blocks moisture, is what we reach for under houses that see standing water or heavy humidity. It costs more than other options, so we use it where the damp calls for it.
Open-cell foam is lighter and softer, and sprayed along the roofline it keeps ductwork in the attic sitting in cooler air. It doesn't handle water well, so it stays out of damp crawl spaces.
We insulate shops, offices and small commercial spaces around Charleston, and we can plan the work around your hours so the business keeps running while we're in the ceilings or walls.
A crawl space vapor barrier, a heavy plastic sheet laid over the dirt, keeps ground moisture from rising into the floor framing, which matters on low, wet lots. We lap and seal the seams so it stays put.
Beyond crawl spaces, we put vapor barriers where moisture moves through walls and ceilings, on the side this humid climate calls for, since one on the wrong side can trap water inside the wall.
Before topping up an attic, we seal around the hatch, plumbing vents and wire holes, because air moving through those gaps carries heat and moisture right past the insulation.
Retrofit insulation adds to a finished house without tearing it apart, by filling walls, topping up attics or working from the crawl space. We plan the order so nothing gets covered before it's sealed.
Send the form and we'll reply within one business day, by phone or email, whichever you used. Then I come out for a free on-site estimate, with no obligation to go ahead.
The person who looks at your attic and crawl space is the one who writes your quote, and I come back after our installers finish to look the work over with you.
A lot of our calls come from people holding a few quotes they can't tell apart, so ours spells out each step and I'll explain what every line covers.
I spent years selling insulation before I started this business in 2023, and I'd rather lose a sale than talk you into a job your house doesn't need.
These are the questions about permits, licenses and flood zones that come up most when we're quoting insulation work inside Charleston.
The city's residential permit list names work like fences, roofs and solar panels but not insulation, so ask the city's Permit Center rather than assume either way. The same page has a map to confirm your address is inside city limits, and points you to Charleston County's map if it isn't there. If your job needs a permit, we handle the application and keep you posted.
Yes. Any contractor doing business inside city limits needs a City of Charleston business license, even one with no office in the city. The state licenses contractors on top of that, and commercial jobs over $10,000 in the classes it regulates need a General or Mechanical Contractor's license. We're licensed and insured, and it's fair to ask anyone you're comparing to show theirs.
Zones AE and VE are the city's high hazard flood zones, while X is low hazard and X shaded is moderate, both outside the regulated flood area. The city points out that a good share of flood insurance claims still come from those lower-risk zones. That's why I look at how wet your crawl space actually gets before suggesting batts, foam or a vapor barrier.
These are the cities with their own page on our site, not the only places we go. If yours isn't listed, call or send the form and we'll tell you whether we cover it.
We answer seven days a week, 7 AM to 10 PM, so call (843) 278-0544 or send the form tonight.